Bidirectional Forwarding Detection (BFD) Configuration Module

This configuration module configures the basic BFD (RFC5880) parameters. To configure fast failover with BFD, use the routing protocol configuration modules. At the moment you can use BFD with IS-IS and OSPF.

BFD is supported on these platforms:

Operating system

Configurable
timers

OSPF

IS-IS

Arista EOS

Aruba AOS-CX

Cisco IOS

Cisco IOS XE

Cisco Nexus OS

Cumulus Linux

FRR

Dell OS10

Junos[1]

Mikrotik RouterOS 6

Mikrotik RouterOS 7

Nokia SR Linux

Nokia SR OS

VyOS

Parameters

The following parameters can be set globally or per node/link:

  • min_tx: The desired minimal interval for sending BFD packets, in msec.

  • min_rx: The required minimal interval for receiving BFD packets, in msec

  • min_echo_rx: Echo function timer, in msec

  • multiplier: Number of missed packets before the session is considered down

Global defaults are set pretty high to accommodate a wide range of virtual network devices with varying quality of BFD implementation:

  • min_tx: 1 second (1000 msec)

  • min_rx: 1 second (1000 msec)

  • min_echo_rx: disabled (set to zero)

  • multiplier: 3

Valid intervals and ranges are platform-dependent. Some platforms have lower default values:

platform

min-tx

min-rx

nxos

1000 msec

500 msec

srlinux

100 msec

100 msec

sros

100 msec

100 msec

Example

To enable BFD using default values on all IS-IS interfaces:

module: [ isis, bfd ]

isis:
 bfd:
  ipv4: True
  ipv6: True